Facts

Most Wrapz are 1.5"x3" (with the exception of larger Wrapz wich are 2" x 3") to allow for trimming. Make sure that you pay close attention to the size and type of battery that you are wanting to cover before your order. Also note that your Battery may not fit the charger after installation. For this reason we ask that you make sure that your charger has a little room around the edges when the battery is installed.  

NOTE:
 Only known issue is with the VOLCANO's 510 MAGMA charger as they are a very snug fit without the wrapz. Our number one suggestion is to buy an adapter that can be found at: http://www.totallywicked-eliquid.com/products/tornado-e-ni-accessories/tornado-battery-mains-charger-adaptor-product.html  This will alow you to charge your batt but it still may not fit in your PCC.

You can also purchase volcanos USB M charger that will allow you to charge your Batt with the wrap on (with a little trimming of the well wall.) You can find it here: http://www.volcanoecigs.com/volcano-electronic-cigarette-accessories.html?cat=11ww.

However the L88 or VOLCANO fits in all of its chargers just fine including the PCC.

Fits 901, 510, L88 and any other Battery within the 1.5" Circumference and 3" length.
Larger wrapz will fit a bat within 2" cicumference and 3" length. (Such as the T-Rex and Tornado.)

* Evolution Wrapz are made from an ultra thin vinyl, printed and then protected with a laminate for extra durability.
* They will fit most Batts on the market today within a 1.5" Circumference.
 (Please note that graphics will fit most size batteries but in most cases have to be trimmed to fit)
* You wrap your Batts at your own risk. We are not responsable for any damage that may occur during installation.

VIDEO COMING SOON!!

Installing your wrap is easy. Here is a step by step tutorial:

Things you will need:
*Alcohol or alcohol swab.
*Razor blade, Exacto knife or scissors.
*Ruler or straight edge.

Step 1:    Wash your hands and clean your battery with alcohol to remove any oil.
              Make sure to dry the battery off.

Step 2:  A. Place the battery over the wrap graphic side up makeing sure that the graphic is centered where you want it.
              B. Mark the length of your batterie edge to edge. The battery's cover not end to end.
              C. With the straight edge, trim the length of your your battery on the top and bottom of your wrap.

Step 3:   With the backing still in place wrap the wrap around your battery and line up the ends on the other side with each other.
              Take note of how much over lap there is. This will be your guage for trimming the width. You will leave a bit on each side so
              that there is some overlap when the wrap is applied. Trim both sides as needed.
              If you are wrapping a MANUAL bat then at this point you need to line up the Wrap and notch out the spot for the button on one side

              of  the wrap.

Step 4:    Peel back the backing just enough to expose about 1/8" across one side. Line it up with the length of the battery. Make sure
               that it is straight and lined up.

Step 5:    When you are happy with the placement and that there is no extra trimming needed slowly start to wrap the wrap around your

               battery, pressing it into place as you go from the center to the edges. Remove the backing as you go.
               Stop right before it is completely wrapped and make sure that you don't need any more trimming from the last edge.
               If no other trimming is not needed finsh wrapping. Press the edges down firmly to secure it and your done.

Step 6:   Enjoy vaping with your newly wrapped battery :o)